Frigidaire Side By Side Ice Maker Not Working

The ice maker signal arm should be in the down.

Frigidaire side by side ice maker not working.

The ice maker should produce 2 to 3 pounds of ice per 24 hours depending on usage. The gear box turns very slowly but has lots of power to push the ice. However the green coloured inlet line that leads from the bottom to the upper back of the fridge dos not seem to have water in it. If the ice maker is not working the ice level control board might be defective.

What should i do if my ice maker is not making enough ice in my refrigerator. The water filter may be clogged or overdue for replacement. If you are able to blow air into the waterline then the valve is bad and will need to be replaced. If you ice maker is not making enough ice here are few things to check.

In addition check to see if frost has accumulated on the evaporator coils. Trace the line from the ice maker down the back side of the unit to the valve now pull the water line for the ice maker out of the valve and blow into the waterline. We can help you diagnose your problem as well as replace parts like broken fridge door handles or storage shelves. The filter cartridge is a brand new one.

The ice bin will hold about 4 pounds of ice. The freezer temperature should be set between 0 and 5 degrees fahrenheit 18 to 15c for the ice maker to work properly. The ice bucket auger is located in the ice bin and when the dispenser is activated will rotate to pull the ice forward to the outlet chute of the bin. It is more likely that a single part has failed.

As the level of ice reaches the top the beam is interrupted and the ice maker shuts off. If the entire dispenser system is not working the control board is more likely to be at fault. If only one dispenser par t is not working test each of the dispenser components before testing the control board. Ice maker isn t making ice.

The refrigerator is equipped with an infrared light beam to detect the level of ice in the ice bucket. If the freezer temperature is too high ensure that the condenser coils are clear of debris and the condenser fan is working properly. The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft.