Ensure plug is tightly pushed into outlet.
Frigidaire freezer not running.
If your freezer won t start one of the most common parts to fail is the compressor start relay.
10 possible causes and potential solutions.
The temperature control will sense this increase and cause the compressor to run almost continuously to try and lower the temperature.
Not running if the freezer has electrical power the inside light turns on but the compressor won t run a failed cold control thermostat could be the problem.
Freezer not working clicking sound.
A fuse is blown in your house or a circuit breaker is tripped.
Electronic controls are complex and expensive.
2 possible causes and potential solutions.
Freezer may not be plugged in or plug may be loose.
If your freezer has electronic controls instead of a dial a failed relay on the electronic control board or a bad control panel can prevent the compressor from.
What should i do if my freezer isn t running.
If you are unsure about the outlet have it checked by a certified technician.
If the start relay isn t working properly the compressor may run intermittently or may not run at all.
Search help by model.
Water on the coils may be due to high usage or high humidity.
Common frigidaire freezer upright problems include ice makers that won t function properly frost buildup water leaking and the temperature falling or the machine not working at all.
Sometimes called the controller this device is used to energize the compressor start windings until the unit is running and it usually contains the overload protection component as well.
If your refrigerator will not start the control board could be at fault.
The control knob is turned to off.
There is a temperature setting knob located inside the fridge.
Use another circuit.
The start relay provides power to the compressor.
Freezer is plugged into a circuit that has a ground fault interrupt.
Freezer does not run.
To determine if the start relay is defective unplug the freezer and remove the start relay from the compressor.
If the thermostat does not have continuity then the heater will not get energized and the evaporator will become blocked with frost or ice allowing the freezer temperature to rise.
Temperature control is in the off position.
Frigidaire freezer repair help.
If the temperature is set too high the compressor will not kick in and the fridge will not cool so adjust the knob so that it is set to a lower temperature and see if the compressor starts.
If the frigidaire upright freezer is leaking water then you may need to check the evaporator coils.
You should first verify that there is no power being supplied to the compressor that you have incoming power to the control board and that the external controls are functioning properly before condemning the electronic control.
Step 2 check the temperature.
Need help finding your model number.
