The requirement became effective on october 1 2007.
Florida roof sheathing thickness.
The cap nail shank shall be not less than 0 083 inch for ring shank cap nails and 0 091 inch for smooth shank cap nails.
Where the sheathing thickness is 15 32 inches and less roof.
Fasteners shall comply with astm f1667.
Fasteners for asphalt shingles shall be galvanized stainless steel aluminum or copper roofing nails minimum 12 gage 0 105 inch 2 67 mm shank with a minimum 3 8 inch diameter 9 5 mm head of a length to penetrate through the roofing materials and a minimum of 3 4 inch 19 1 mm into the roof sheathing.
The typical thickness range for sheathing is 3 8 to 3 4 inch.
This minimum will only work if the rafters are set 16 inches apart at most and if the roof doesn t have too much load.
Allowable spans for lumber floor and roof sheathing a b for si.
The roof sheathing plywood or osb has to be be nailed with 8d eight penny ring shank round head nails at six inches on center.
Minimum thickness of the outside edge of plastic caps shall be 0 035 inch.
If it was originally secured using staples or 6d nails it must be completely re nailed to the new standard.
While ring shank nails are still required the nail size depends on the sheathing thickness.
Roof sheathing comes in grid marked 4 by 8 foot sheets and should be installed perpendicular to the frame.
Never attach roof sheathing with staples.
For closed valleys valley lining of one ply of smooth roll roofing complying with astm d 6380 classsand atleast36 inches 914 mm wide or valley lining as described in item 1 or 2 above shall be permitted.
Installation details shall conform to sections 2304 7 1 and 2304 7 2 for floor and roof sheathing respectively.
Where the roof sheathing is less than 3 4 inch 19 1 mm thick the nails shall penetrate through the sheathing.
Floor or roof sheathing conforming with this table shall be deemed to meet the design criteria of section 2304 7.
Roof sheathing thickness unlike with plywood siding the plywood sheet to be used for sheathing should be at least 3 8 inch thick.
The bottom layer shall be 18 inches 457 mm and the top layer a minimum of 36 inches 914 mm wide.
Cap nail shank shall have a length sufficient to penetrate through the roof sheathing or not less than 3 4 inch into the roof sheathing.
1 inch 25 4 mm.
That s considered to be the minimum.
8d ring shank nails should be used instead.
