Flashing A Deck Ledger Board On Vinyl Siding

I would remove the old siding that was behind the existing ledger to about an inch above the deck surface.

Flashing a deck ledger board on vinyl siding.

Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck. Attaching a deck to your house creates the potential for rot not only to the ledger board that you attach to the house to support the. Infiltrating rainwater can travel downward sideways and even upward so special flashings must be used. Then slip flashing behind the siding covering the top edge of the ledger.

Start by making an outline on the siding where you want to position the ledger board. How to use flashing between vinyl siding and a wood deck. These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim. Most house framing relies on building elements floors walls roofs being stacked one atop another.

7 apply silicone caulk around the screw heads to prevent moisture from penetrating into the wall. My instinct is to replace the deck and eliminate the ledger altogether add posts near the wall and leave a big gap between the end board and new flashing tucked under the siding. Item 3807 model 5504900120. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.

The deck ledger to the house is an unusual connection in home building. How to flash a deck ledger board if you cut out your siding to install a ledger board careful steps must be taken to ensure that moisture cannot reach your house.