Fish Wire Into Attic

If you re working from the attic you can drop a weighted string down wall cavity then attach the wire to the string and pull it through.

Fish wire into attic.

The presumption is that the cable run will be looped from one box location down or up into a basement crawlspace or an attic then across floor joists before entering the stud cavity where the next box is located. Bring all of the wire up into the attic. Glow rods can also be used to hook wires to pull them out as a wire snake tool. Attach the wire or cable to a fish tape or coat hanger using electrical tape and feed it into the hole until it reaches the opening at the other end.

Once your hole is drilled you can shove a glow rod through the hole to start fishing wire attach your wire to the eyelet at the end and pull it back through. Once the string reaches the bottom go down to the lower opening and tie the cable and string together. Many attics don t have any provision for this so you ll have to stretch across the rafters. If you want to bring the wire up to the attic tie something to a string and lower it through the hole from above.

Fishing the wires is quite easy when you attach them with a fish tape or a pull wire. The staple gun should be loaded with wire staples designed for holding the size and type of wire you are running. How to fish a wire from the wall or through walls to the ceiling or how to fish a wire from the attic to the ceiling is needed like when you need to install. Attach the wiring in the 3 by 5 inch hole to the end of the fish tape.

Pull the wiring through the wall by reeling in the fish tape bringing it out through the hole for the electrical box. Pull the string from above to fish the wire through. Run the wire or cable to its destination. While one person holds the flashlight the other person should use a staple gun to run the wire along the rafters from one entry hole to the other.

As their name suggests glow rods glow in the dark.